自重湿陷性黄土地基预钻孔浸水处理的可靠度设计方法

为解决传统预浸水法存在的浸水时间长、浸水处理范围难以确定等不足,基于土体中水分运移规律,依据可靠度理论、极限状态设计方法及复合 Poisson 过程原理,提出一种消除黄土湿陷性的处理浸水方法——预钻孔浸水法。给出了利用预钻孔浸水法对自重湿陷性黄土地基进行浸水时,水平向及竖直向浸水影响范围的确定模型;在此基础上结合达西定律给出了浸水孔设计参数如孔深、孔间距及浸水孔个数的确定方法。结合铜川某工程,设计进行了现场预钻孔浸水试验,对该方法的合理性进行了验证,并通过现场钻探、现场勘探、室内湿陷性试验等方法对该方法的处理效果进行了评价。该浸水方法具有浸水时间短、浸水影响范围可根据浸水孔布设进行控制等优点,且浸水处理效果良好,完全符合施工要求。     

电磁场与电磁波课程思政教学改革探索与实践

课程思政作为思想政治理论课程的有效补充，是落实立德树人根本任务的重要组成。《电磁场与电磁波》是物理、电类等专业的重要专业基础课程，深入挖掘其课程思政元素,能够发挥专业课程的隐性育人作用，实现知识传授、能力培养与价值引领的有机融合，对于理工科专业课进行课程思政改革具有现实指导作用。     

温度对核电站传热管阵列声透射特性的影响

为了研究温度分布对于管阵列结构中的声透射特性的影响，以核电站的实际工况为背景，构建了不同的温度场以及周期性变化的非均匀温度场，利用有限元方法进行数值模拟。结果表明：（1）温度分布会改变管阵列声透射频谱的“禁带”宽度以及中心频率位置。在同一介质中，温度变化对频率较高位置的影响大于频率较低的位置。（2）在同样为10℃的温度差下，当水的平均声速为1 653 m·s^-1、饱和水蒸气的平均声速为522.5 m·s^-1时，介质为水时的禁带宽度及中心频率位置变化较大，即声速大的介质的频谱对于温度的变化更敏感。（3）当温度差在10℃以内，在周期性变化的非均匀温度场和与均匀温度场中管阵列声透射特性在第一中心频率23 996.1 Hz之前，两频谱差别很小，在第一禁带之后会出现明显区别。该研究成果对完善核电站应用的声学检测提供了理论基础。     

120m高钢筋混凝土烟囱爆破拆除

介绍了用定向控制爆破方法拆除吉化电石厂120m钢筋混凝土烟囱的经验。针对该烟囱下部有1个门和3个窗户的特殊结构,选择倒梯形爆破切口,以增强预留支撑面的强度。为防止烟囱落地产生震动和前冲,在倒塌的前方设置了减震带和阻冲挡土墙。文中同时还阐述了参数的选择与计算,以及爆破效果。文中总结的四点经验值得借鉴。     

减振沟对爆破振动加速度峰值减振效应的试验研究

通过对减振沟开挖前后两个阶段爆破振动加速度峰值的监测,采用回归分析的方法,得到两种情况下的萨道夫斯基经验公式。通过对比分析的方法,得到减振沟对振动加速度峰值的减振规律。结果表明,合理的开挖减振沟可有效地降低爆破振动加速度峰值。     

Experimental and numerical study on tube-side flow and heat transfer characteristics of superheated vapor flow in catalyst-filled LH2 spiral wound heat exchanger

High energy consumption is considered to be one of the most persistent problems in liquid hydrogen (LH₂) plants. The combination of heat exchanger and ortho-para (O–P) hydrogen conversion has attracted considerable attention as a cutting-edge technology to reduce energy consumption. The flow and heat transfer characteristics of O–P hydrogen conversion catalyst-filled spiral wound heat exchanger (SWHE) were investigated in this study in two steps. In the first step, pressure-drop experiments were performed in a tube filled with porous media. The results indicated that the pressure drop was overestimated when using Ergun's equation. Therefore, a new empirical pressure-drop correlation for a channel filled with O–P catalyst was formulated. Subsequently, a novel heat transfer model was established based on this correlation for further numerical simulations. The distributions of the temperature, pressure, and para hydrogen content in a catalyst-filled tube were determined. In addition, the influence of the flow rate on the heat exchange coefficient and outlet para hydrogen was clarified; it was found that, with an increase in the flow rate, the heat exchange coefficient increased, whereas the outlet para hydrogen content decreased. At a flow rate of 0.5 m³/h, the para hydrogen content increased by 44% after hydrogen flowed through the channel filled with the O–P catalyst. Furthermore, a prediction model for the para hydrogen content with a flow rate range of 0–1.5 m³/h was derived. This study provides promising theoretical evidence for the engineering application of SWHEs filled with O–P catalysts in large-scale hydrogen liquefaction units.     

An active balancer with rapid bidirectional charge shuttling and adaptive equalization current control for lithium-ion battery strings

This article proposes an active balancer, which features bidirectional charge shuttling and adaptive equalization current control, to fast counterbalance the state of charge (SOC) of cells in a lithium-ion battery (LIB) string. The power circuit consists of certain bidirectional buck-boost converters to transfer energy among the different cells back and forth. Owing to the characterization of the open-circuit voltage (OCV) vs SOC in LIB being relatively smooth near the SOC middle range, the SOC-inspected balance strategy can achieve more precise and efficient equilibrium than the voltage-based control. Accordingly, a compensated OCV-based SOC estimation is put forward to take into account the discrepancy of SOC estimation. Besides, the varied-duty-cycle (VDC) and curve-fitting modulation (CFM) methods are devised herein to tackle the problems of slow equalization rate and low balance efficacy, which arise from the diminution in balancing current as the SOC difference between the cells decreases in the later duration of equalization especially. The proposed strategies have taken the battery nonlinear characteristic and circuit parameter nonideality into account and can adaptively modulate the duty cycle with the SOC difference to keep balancing current constant throughout the balancing cycle. Simulated and experimental results are given to demonstrate the feasibility and effectiveness of the same prototype constructed. Compared with the fixed duty cycle and the VDC methods, the proposed CFM has the best balancing efficiency of 81.4%, and the balance time is shortened by 27.1% and 18.6%, respectively.     

切顶卸压技术在双鸭山矿区沿空留巷中的应用

为了使双鸭山矿区煤炭资源最大程度地被采掘,减少资源浪费,提高矿井效益,延长矿井服务年限及促进矿井安全生产,以双鸭山矿区3个缓倾斜中厚煤层综采工作面为工程背景,对切顶卸压无煤柱开采技术进行深入探索,经过实际的检验证明,在双鸭山矿区缓倾斜中厚煤层中,采用切顶卸压技术进行沿空留巷,技术可行,经济合理,工艺简单,成巷率高。     

从蚕的生命到艺术：中国古代生命观的哲学表达

中国考古出土的蚕业实物及蚕的艺术形象比较丰富,蚕的艺术形象如蚕纹、陶蚕蛹、牙雕蚕、玉石蚕、铜蚕、金蚕等,可统称为"蚕的模拟形态"。对蚕的模拟形态的功用,已有的诸多解释都有待完善。研究表明,蚕的模拟形态或艺术形象表达的功用或为饰品,或为装饰图案,或有待进一步考究。但无论哪种功用,用"蚕"这一形象都蕴含了特有的用意。通过对中国古代生命观的考察,文章认为蚕的艺术形象折射出相应的中国古代哲学生命观,即中国古人追求的死而复生、生生不息、羽化成仙、长乐无极等观念。